Vaillant geoTHERM SERIES Service Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
Operating Manual geoTHERM exclusive VWS 0020071929_0018
Display shown Description
Energy input display
Shows the energy extracted from the environment for each of the 12
months of the current year (black bar). White-filled bars represent the
future months of the year; the height of the bar corresponds to the
yield for the month in the previous year (comparison possible). On
commissioning, the height of the bars is zero for all months, as no in-
formation is available yet.
The scaling (in the example, 4000 kWh) adapts automatically to the
month's highest value.
Top right the total of the environmental yield since commissioning is
displayed (in the example: 13628 kWh).
Mon. 21.04.08 16:49 1
Current flow temp. 28°C
CH pressure 1.2bar
Brine pressure 1.4bar
Heating only comp.
Warning message
Warning message
Day, date, time as well as flow temperature, heating system pressure
and heat source pressure are displayed.
Current flow temp: Current flow temperature in the unit.
Heating system pressure: Pressure sensor heating circuit.
Pressure heat source: Pressure of the heat source (pressure sensor,
heat source circuit, brine pressure)
Heating only comp.: this status message provides information on the
current operating status.
The following are possible:
CH: Comp. only.
CH: Comp+Aux
CH: Aux only
CH: Comp&aux off
DHW: Comp&aux off
DHW: Comp only
DHW: aux only
Peak Rate: WW
Peak Rate: Stand-by
Acceleration mode
Frost prot. Heating
Frost prot. Cylind.
Legionella protect.
Automatic pump spin
Floor drying
Venting mode
Fault shutdown: heating
Error shutdown: heating
Fault shutdown: DHW
Error shutdown: DHW
Malfunction
Blocking error
Operation interlock
CH Comp overrun
WW Comp overrun
Cooling & WW
CH return too high
Under critical operating conditions a warning message is displayed in
both lower display lines. These lines are empty when the operating
conditions are normal.
Table 5.1 Adjustable parameters at the operator level (contd.)
5 Operation
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Comments to this Manuals

No comments