Vaillant auroTHERM exclusive VTK SERIES Installation Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 72
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
2 Safety
6 Installation manual auroTHERM exclusive 0020077994_02
2 Safety
2.1 Action-related warnings
Classification of action-related warnings
The action-related warnings are classified in accordance
with the severity of the possible danger using the following
warning signs and signal words:
Warning symbols and signal words
Danger!
Imminent danger to life or risk of severe per-
sonal injury
Danger!
Risk of death from electric shock
Warning.
Risk of minor personal injury
Caution.
Risk of material or environmental damage
2.2 Required personnel qualifications
This manual is intended for persons with the following qual-
ifications
2.2.1 Authorised competent person
The installation, assembly and removal, start-up, mainten-
ance, repair and decommissioning of Vaillant products and
accessories must only be carried out by authorised compet-
ent persons.
Note
Each competent person is qualified for specific
activities on the basis of their training. They
must only work on units if they have the re-
quired qualification.
When working on the units, the competent persons must
observe all applicable directives, standards, laws and other
regulations.
2.3 General safety information
2.3.1 Danger due to improper use
Vaillant auroTHERM VTK tube collectors are constructed
using state-of-the-art technology in accordance with the re-
cognised safety rules and regulations. Nevertheless, there
is still a risk of injury or death to the user or others or of
damage to the unit and other property in the event of im-
proper use or use for which it is not intended.
2.3.2 Risk of death due to improper fastening
systems
The collectors may fall due to improper fastening systems.
Only the combination of Vailllant collectors and Vaillant
fastening systems has been tested. This combination can
withstand the forces caused by additional wind and snow
loads.
Only use the collector fastening systems that are ap-
proved by Vaillant.
2.3.3 Risk of death due to inadequate load-
bearing capacity of the roof
A roof with an insufficient load-bearing capacity may col-
lapse due to the additional load of the collectors.
Above all, additional wind and snow loads may result in
higher forces which could cause the roof to collapse.
Ensure that a structural engineer has confirmed the roof
as suitable for collector installation.
Only install the collectors on a roof that has adequate
load-bearing capacity.
2.3.4 Risk of death due to falling parts
Unsecured collectors can fall from the roof and present a
danger to persons.
Block off the areas in the fall area below the place of
work to a sufficient extent so that persons cannot be
injured by falling objects.
Indicate the working area, e.g. with information signs, in
accordance with the applicable regulations.
2.3.5 Risk of injury and material damage due to
incorrect maintenance and repairs
If maintenance or repair work is not carried out, or is car-
ried out incorrectly, this may result in injuries or in damage
to the solar plant.
Ensure that only an approved competent person carries
out maintenance and repair work.
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 71 72

Comments to this Manuals

No comments