Vaillant ecoCRAFT VKK GB SERIES Installation Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
13Operating manual ecoCRAFT
6.5 Measuring and checking work by the chimney
sweep
1
Fig. 6.1 Chimney sweep measurements/combustion check
The checking aperture is installed separately in the
exhaust ducting.
When using a Vaillant exhaust gas duct adaptor for
Vaillant plastic exhaust systems (accessories), there is an
additional facility (1) for checking, at the back, on the
right hand side, just above the cladding cover.
If a Vaillant VRT heating regulator is connected in, the
"chimney sweep operation" should be set there in order
to carry out the measurements.
If the heating installation is not operated with a
regulator that has a "chimney sweep operation" mode,
you can set the boiler to maximum output by the use of
a combination of buttons.
This is done by pushing down and holding the buttons
"Mode" and "+" for five seconds.
Note!
The test programme is automatically exited
after 15 minutes.
All burner modules are switched to full load.
The measurements should be taken at the earliest
after 2 minutes of operation of the unit.
7 Customer service and warranty
7.1 Vaillant service
To ensure efficient and reliable operation of your boiler
it is recommended that regular servicing is carried out
by your service provider.
Vaillant Applied System Sales
Vaillant Ltd., Unit D1 Lowfields Business Park, Elland.
West Yorkshire. HX5 9DG
Training
Telephone 01634 292370
Fax 01634 292354
email training@vaillant.co.uk
Commercial Service
Telephone 0870 850 3072
Mon - Fri 8.30 - 17.30
Fax 01773 525 946
email aftersales@vaillant.co.uk
7.2 Vaillant warranty
Vaillant provide a full parts and labour warranty for this
appliance.
The appliance must be installed by a suitably competent
person in accordance with the Gas Safety (Installation
and Use) Regulations 1998, and the manufacturer’s
instructions. In the UK ‘CORGI’ registered installers
undertake the work in compliance with safe and satisfac-
tory standards.
All unvented domestic hot water cylinders must be
installed by a competent person to the prevailing buil-
ding regulations at the time of installation (G3).
Terms and conditions apply to the warranty, details of
which can be found on the warranty registration card
included with this appliance.
Failure to install and commission this appliance in com-
pliance with the manufacturer’s instructions may invali-
date the warranty (this does not affect the customer’s
statutory rights).
Care and maintenance 6
Customer service and warranty 7
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments