Vaillant VRC 430f Installation Manual download pdf (Page 29)

9Installation Instructions VRC430 0020042468_02

6 Initial start-up

Initial situation:

The controller and the external sensor are correctly in-

stalled and connected.

The heating unit is switched on and ready for operation.

Note!

Ensure that both rotary knobs

(outlet-/hot water cylinder temperature and

heating flow temperature ) on the boiler are at

the maximum position (all the way to the right).

This ensures optimum control system by the

VRT 430.

The VRC 430 operating concept is described in the op-

erating instructions in Chapter 4.3.

6.1 Installation assistant

The installation assistant will help you with the initial

start-up. The installation assistant

recognises the components connected to the heating

system.

Depending on the configuration of the heating unit, up

to six screens (A1 to A6) are available. You can enter

the most important parameters of the heating system

using the installation assistant.

The installation assistant starts with screen A1, language

selection.

⇒ Select the language as per the operating concept

(operating instructions 4.3).

⇒ Turn the left-hand dial clockwise by one click to ac-

cess screen A2.

Installation assistant

System configuration

Mixer mode HC1

> Select

Cylinder

active



A 2

Fig. 6.1 Installation assistant screen A2

The heating system configuration is shown on screen

A2.

In the heating circuit mode HC1 you can select between

burner circuit (BK) and inactive.

In Cylinder you can choose between active and inactive.

⇒ Turn the left-hand dial clockwise by one click to ac-

cess screen A5.

You can check the heating generator settings on screen

A5:

⇒ Select 50 °C as the parameter value for the "Activa-

tion heater" parameter.

⇒ Check the boiler reaction.

If you want to make any other changes:

⇒ Turn the left-hand dial anticlockwise to return to

any of the previous screens.

To exit the installation assistant:

⇒ Turn the left-hand dial clockwise to access screen

A6.

⇒ Click "Yes" to exit.

Note!

If you confirmed the end of the installation with

"yes" you can only access the installation as-

sistant via the code-protected Expert Techni-

cian Level.

6.2 Expert technician level

The expert technician level is used to display and set/

change specific operating data. This allows the control

system to be set according to the heating system. This

is advisable if the heating installation has other compo-

nents in addition to the heating circuit 1 (HC 1)(e.g. heat-

ing circuit 2, domestic hot water cylinder, solar energy

system).

Note!

Please refer to the individual operating manuals

for component controller function descriptions.

The expert technician level includes screens C1 to C26

and the screens A1 to A6 of installation assistant as de-

scribed above.

Screens C1 to C26 in the VRT 430 appear in the same

sequence as shown in table 6.1 below.

This table shows the parameters which can be set and

changed.

Depending upon the configuration selected, non-re-

quired parameters are not displayed on the installation

assistant (screen A2).

The settings/changes take place in accordance with the

operating concept as described in Chapter 4.3 of the op-

erating instructions .

In order to get to the expert technician level, you need

to enter an access code.

From the simplified basic display you can access the ex-

pert technician level as follows:

Initial start-up 6

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Comments to this Manuals

No comments

Vaillant VRC 430f Installation Manual Page 29

Comments to this Manuals

Related products and manuals for Thermostats Vaillant VRC 430f