Vaillant climaVAIR V 7-035NW Installation Manual download pdf (Page 16)

Split Type Installation Manual16

Split Type Installation Manual 17EN

Warning!

Danger of breakdowns or malfunction.

Size the electric wiring with sufficient capacity.

Warning!

Danger of breakdowns or malfunction.

Compliance with the Standard EN 61000-3-11:

Check that the nominal power of the main phase

current connection is > 100.

Warning!

Danger of breakdowns or malfunction.

Ensure that the supplied power voltage is in the

range of 90% to 110% of the rated voltage.

Warning!

Install the unit in such a way that the electric

plug is easily accessible. Thus, if required, the

unit can be quickly disconnected.

11.2 Remark with regard to Directive 89/336/EEC

In order to prevent electromagnetic interference during

the start up of the compressor (technical process), the

following installation conditions must be adhered to.

• Make the air conditioning unit power supply

connection at the main power distribution. Carry out

the distribution with low impedance. Normally the

required impedance is reached at a

32 A fusing point.

• Check that no other equipment is connected to this

power supply line.

Note!

For more detailed information on the electric

installation, please consult the Technical

Connection Conditions applied by your electricity

supply board.

Note!

In order to obtain more information with regard

to power details of the air conditioner consult

the unit rating plate.

11.3 Electric Connection of the Indoor Unit

Warning!

Danger of breakdowns or malfunction. If the fuse

on the PC board is blown please change it

with type T. 3,15A/250V.

• Disassemble the outdoor body of the indoor unit by

pulling it upwards.

• Remove the wiring cover on the right of the body by

unscrewing it (see Figure 11.1).

Fig. 11.1 Wiring Cover.

• Insert the cable from the outside:

• Using the same hole through which the coolant pipes

are installed (or are going to be installed later) or,

• Using another of the pipe installation windows

provided on the body.

• Pull the electrical cable from the rear of the indoor

unit through the specific hole in the front.

• Connect the line on the terminal strip of the indoor

unit according to the corresponding wiring diagram

(see Figures).

11 Electric Wiring

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments

Vaillant climaVAIR V 7-035NW Installation Manual Page 16

Comments to this Manuals

Related products and manuals for Split-system air conditioners Vaillant climaVAIR V 7-035NW