Vaillant climaVAIR V 7-035NW Installation Manual download pdf (Page 9)

Split Type Installation Manual8

Split Type Installation Manual 9EN

8.3 General Installation Diagram

Warning!

Danger of breakdowns or malfunction.

Observe the minimum assembly distances

indicated in Figure 8.1.

Fig. 8.1 General diagram of the installation and the minimum

assembly distances.

Legend

1 Indoor Unit

2 Outdoor Unit

3 Pipe for draining the condensed water

A Front separation (minimum 10 cm)

B Top separation in relation to the ceiling (minimum 5 cm)

C Separation fixing wall (minimum 10 cm)

D Height in relation to the floor (minimum 2 m)

E Side separation opposite side connections (minimum 10 cm)

F Rear separation (minimum 10 cm)

G Side separation connections side (minimum 15 cm)

H Front separation (minimum 60 cm)

9 Installation of the Indoor Unit

9.1 Selecting the Assembly Location

Warning!

Danger of breakdowns or malfunction.

Observe the minimum assembly distances

indicated in Figure 8.1.

Note!

If a hole already exists in the wall or a coolant

pipe or condensed water pipe has already been

installed, the base plate can be mounted to adapt

to these conditions.

Recommendations

- Install the indoor unit close to the ceiling.

- Choose a mounting site that will allow air to reach all

parts of the room evenly. Avoid beams, installations or

lights which obstruct the airflow.

- Install the indoor unit at an adequate distance from

chairs or workstations in order to avoid unpleasant

draughts.

- Avoid close heat sources.

9.2 Fixing the Assembly Plate

Carry out the steps described below:

• Place the mounting plate on the chosen installation

point.

• Level the plate horizontally and mark the holes to be

made on the wall for the installation using the screws

and rawplugs.

• Remove the plate.

Warning!

Danger of breaks in the domestic installation.

Check that there are no electricity lines, pipes or

any other element which could be impaired

behind the spots where the holes are to be

drilled.

If so, choose another installation location and

repeat the aforementioned steps..

• Make the holes using a drill and insert the rawplugs.

• Place the assembly plate in the assembly location,

level it horizontally and fix it with the screws and the

rawplugs.

Warning!

Danger of breakdowns or malfunction.

Ensure that the assembly plate has been

correctly levelled.

Otherwise, disassemble the plate and assemble it

again correctly.

Installation 8

Installation of the indoor unit 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Comments to this Manuals

No comments

Vaillant climaVAIR V 7-035NW Installation Manual Page 9

Comments to this Manuals

Related products and manuals for Split-system air conditioners Vaillant climaVAIR V 7-035NW