Vaillant auroMATIC VRS 560 Installation Manual download pdf (Page 14)

4 Installation Manual auroMATIC 560

ProE-system wiring

C1/C2

C1 C2

KOL1

SP1

SP2

SP3

Ertrag

KOL2

230 V~

PE N L

KOL1-P

PE N L

LEG/BYP

PE N L

LP/UV1

PE N L

KOL2-P/Z P

PE N L

Fig. 4.4 Fold-up the control panel

• Fold the control panel towards the top.

• Wire the controller according to the selected hydraulic

plan (see Section 5.1).

• Secure all cables with the accompanying cable clamps

(3).

• Fold the control panel back down.

• Attach the front cover again.

5 Electrical installation

The electrical connection may only be carried out by an

approved specialist company.

Danger!

Risk of fatal electric shock from touching live

connections. Before working on the appliance,

turn off the power supply and secure against

restart.

Caution!

The circuit board can be damaged if short

circuited through the connection leads. For

safety purposes, a max. of 30 mm of insulation

may be removed from the ends of 230 V leads

which will be connected to ProE plugs. If more

insulation is removed, there is a risk of short

circuiting the circuit board.

Caution!

When exchanging the controller in an existing

system, sensor-curve characteristics should be

taken into consideration (see Sec. 11), and the

sensors should be replaced if necessary!

Caution!

An optional electric heating rod (EP) must be

installed with an additional relay or contactor

with a circuit-breaking capacity of at least 16 A.

Never operate an electric heating rod in connec-

tion with the auroMATIC 560 without an addi-

tional external relay or contactor.

Caution!

The C1/C2 contact is a 24 V low-voltage con-

tact and should never be used as a 230 V

switching contact.

4 Installation

5 Electrical installation

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Comments to this Manuals

No comments

Vaillant auroMATIC VRS 560 Installation Manual Page 14

Comments to this Manuals

Related products and manuals for Unknown Vaillant auroMATIC VRS 560